F 550 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
Oil Pressure Sender: Service and Repair
ENGINE OIL PRESSURE (EOP) SWITCH
Removal and Installation
1. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
Turn the ignition switch to the OFF position.
2. Remove the turbocharger inlet tube.
3. Disconnect the engine oil pressure (EOP) sensor electrical connector.
4. Remove the EOP sensor.
-
To install, tighten to 12 Nm (9 lb-ft).
5. To install, reverse the removal procedure.
