F 550 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
7. Evenly position heat shrink tubing over wire repair.
NOTE: Overlap tubing on both wires.
8. Use heat gun to heat the repaired area until adhesive flows out of both ends of heat shrink tubing.
9. Reconnect battery ground cable.
Recommended splicing method - Crimp (For 10-22 AWG Diameter Wire)
1. Disconnect battery ground cable.
2. Strip 1/4" (6.35mm) of insulation from each wire end, taking care not to nick or cut wire strands.
3. Install heat shrink tubing.