F 550 2WD Super Duty V8-6.4L DSL Turbo (2008)
Body / Frame Mount Bushing: All Technical Service Bulletins
Body - Cab Mount Bolt Removal
TSB 07-12-8
06/25/07
SERVICE TIP - CAGE NUT SPINNING - CAB OFF
SERVICE PROCEDURE
FORD:
2008 F-Super Duty
ISSUE
Some 2008 F-Super Duty vehicles equipped with a 6.4L engine may exhibit a cage nut which spins, making it difficult to remove the cab for service.
Using an air tool may worsen this condition.
ACTION
Follow the Service Procedure steps to gain access to the spinning cage nut.
SERVICE TIP
NOTE
IT IS MANDATORY TO USE ONLY HAND TOOLS TO REMOVE BODY MOUNTING BOLTS.
NOTE
THE BOLTS ARE DESIGNED TO STRIP BEFORE THE NUT AND A STRIPPED BOLT DOES NOT NECESSARILY MEAN THE NUT HAS
BEEN DAMAGED. NUTS SHOULD BE EXAMINED FOR DAMAGE BEFORE THEY ARE ORDERED.
1.
Front cage nut - remove left hand headlamp assembly.
2.
Second cage nut - remove inner fender well and body plug.
3.
Third and fourth cage nuts access - in cab under carpet.
For additional information on Body Retainer Cage Nuts, reference the 2008 F-Super Duty Workshop Manual, Section 502-02.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT:
Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
MT071208
Claim Labor As Actual
Actual
Time
Time
DEALER CODING
CONDITION
BASIC PART NO.
CODE
70101 C58
24
