F 550 2WD Super Duty V8-6.4L DSL Turbo (2008)
Remove the fuel cooler radiator top bolt. Lift the fuel cooler radiator off the retainers and position it aside.
^
To install, tighten to 12 Nm (9 lb-ft).
11. Remove the bolts and the CAC.
^
To install, tighten to 22 Nm (16 lb-ft).
12. Loosen the clamp and disconnect the radiator-to-degas bottle hose from the degas bottle. If equipped, disconnect the vacuum hose near the degas
bottle.
13. Remove the spring clip and disconnect the upper radiator hose from the radiator.
^
To install, make sure the spring clip is installed correctly.
14. Detach the coolant pump-to-fuel cooler hose from the power steering fluid reservoir.
15. Remove the bolts and position the power steering fluid reservoir aside.
^
To install, tighten to 8 Nm (71 lb-inch).
16. Detach the radiator-to-degas bottle hose from the radiator.
17. If equipped, disconnect the vacuum hose at the RH battery tray.
18. Disconnect the electrical connector from the vacuum solenoid, if equipped, or the retainer on the upper fan shroud.
19. Detach the wiring harness retainers from the upper fan shroud and position the wiring harness aside.
20. Remove the bolts and the upper fan shroud.
^
To install, tighten to 7 Nm (62 lb-inch).
21. Position the RH battery positive terminal cover aside, remove the nut and disconnect the battery cable from the RH battery positive terminal.
^
To install, tighten to 12 Nm (9 lb-ft).
22. Position the LH battery positive terminal cover aside and disconnect the LH battery positive terminal from the battery.
^
To install, tighten to 12 Nm (9 lb-ft).
23. Open the hood latch cable connector housing and disconnect the cable and cable retainers.
24. Remove the LH air deflector pushpin.
25. Detach the power steering hose retainer from the radiator.
26. Disconnect the hood cable retainer from the power steering fluid cooler. Remove the bolts and position the power steering cooler aside.
^
To install, tighten to 11 Nm (8 lb-ft).
27. Loosen the clamps and disconnect the transmission cooler hoses.
28. Remove the nuts and disconnect the A/C tubes from the condenser. Remove and discard the O-rings and gaskets.
^
To install, use new O-rings and gaskets.
^
To install, tighten to 15 Nm (11 lb-ft).
29. Remove the RH air deflector pushpin.
30. Remove the spring clip and disconnect the lower radiator hose.
^
To install, make sure the spring clip is installed correctly.
31. Remove the lower cooling fan shroud bolts.
^
To install, tighten to 7 Nm (62 lb-inch).
32. Remove the 6 upper radiator support bolts. With the help of an assistant, remove the cooling module assembly and the RH CAC tube.
^
To install, tighten the upper radiator support top bolts to 40 Nm (30 lb-ft).
^
To install, tighten the upper radiator support front bolts to 63 Nm (46 lb-ft).
33. To install, reverse the removal procedure.
