F 550 2WD Super Duty V8-6.4L DSL Turbo (2008)
Secondary generator
4. Loosen the RH charge air cooler (CAC) tube clamp at the intake throttle adapter and position the CAC tube aside.
-
To install, tighten to 8 Nm (71 lb-in).
Both generators
5. Rotate the accessory drive belt tensioner clockwise and remove the drive belt from the generator pulley.
6. Remove the nut(s) and position the generator B+ terminal(s) aside.
-
To install, tighten primary (lower) generator nut to 12 Nm (9 lb-ft).
-
To install, tighten secondary (upper) generator nut to 10 Nm (89 lb-in).
7. Disconnect the generator electrical connector.
8. Remove the 2 lower bolts to the generator.
-
To install, tighten to 47 Nm (35 lb-ft).
9. Remove the upper bolt and the generator.
-
To install, tighten to 47 Nm (35 lb-ft).
10. To install, reverse the removal procedure.
