F 550 2WD Super Duty V8-6.4L DSL Turbo (2008)
4. Remove the ball joint boot.
5. Remove and discard the shock absorber lower bolt and flagnut.
6. Remove and discard the stabilizer bar link lower bolt.
7. Using the jackstand, lower the front axle enough to install a socket on the C-frame screw.
8. Using the C-Frame and Screw Installer/Remover and the Ball Joint Remover/Installer, remove the ball joint.
Installation
1. Position the ball joint into the bracket.
NOTICE: The grease fitting must be removed from the ball joint prior to installation or damage to the grease fitting can occur.
NOTICE: The ball joint is installed with the dust boot attached to the ball joint. Do not damage the ball joint boot during installation.
2. Using the C-Frame and Screw Installer/Remover and the Ball Joint Remover/Installer, install the ball joint.
3. If removed, install the ball joint grease fitting.
4. Using the jackstand, raise the front axle until the weight of the vehicle is supported by the jackstand.
5. Install the new shock absorber lower bolt and flagnut.
-
Tighten the bolt to 150 Nm (111 lb-ft).
6. Install a new stabilizer bar link lower bolt.
