F 550 2WD Super Duty V8-6.4L DSL Turbo (2008)
14. Remove the special tools.
15. NOTE: If equipped with dual generators, install the upper generator. Refer to Alternator.
Remove the lifting bracket.
16. CAUTION: Only use banjo bolts with a green hex head. Failure to install the correct banjo bolt may result in damage to the
turbocharger.
NOTE: Use a backup wrench to prevent the fittings from turning.
Install new copper sealing washers and banjo bolts on the turbocharger oil feed fittings.
^
Tighten to 38 Nm (28 ft. lbs.).
^
Move the turbocharger actuator linkage through the full range of motion and verify that the turbocharger oil supply tube does not contact the
turbocharger actuator linkage.
