F 550 2WD Super Duty V8-6.4L DSL Turbo (2008)
4. Remove the 2 wheel speed sensor harness-to-axle bolts.
^
To install, tighten to 8 Nm (71 inch lbs.).
5. Remove the wheel speed sensor harness-to-wheel knuckle bolt.
^
To install, tighten to 8 Nm (71 inch lbs.).
All vehicles
6. Remove the 8 wheel extension nuts and the wheel extension.
^
To install, tighten to 176 Nm (130 ft. lbs.).
7. CAUTION: Do not allow the brake caliper to hang from the brake hose or damage to the hose can occur.
Remove the 2 caliper anchor plate bolts and position the caliper assembly aside.
^
Support the caliper using mechanic's wire.
^
To install, tighten to 400 Nm (295 ft. lbs.).
8. Remove the brake disc.
9. Remove the 4 nuts and the wheel bearing and wheel hub.
^
Discard the nuts.
^
To install, tighten to 180 Nm (133 ft. lbs.).
10. Remove the brake disc shield.
Vehicles with ABS
11. Remove the wheel speed sensor bolt and the sensor.
^
To install, tighten to 18 Nm (13 ft. lbs.).
All vehicles
12. Remove and discard the O-ring.
