Exhaust System: EGR Tube Leak Repair for P0299/P132B
(1) Tighten two (2) bolts at EGR inlet pipe to exhaust manifold to 88 lb-in (10 N.m).
(2) Tighten two (2) bolts at EGR inlet pipe to EGR valve housing to 88 lb-in (10 N.m).
f.
Apply Motorcraft(R)Threadlock 262 to the pipe bracket fastener threads.
g. Torque bolt to 88 lb-in (10 N.m) + 45 degrees. (Location A - Figure 1)
h. Tighten the bracket to inlet pipe bolt to 88 lb-in (10 N.m) + 45 degrees. (Location B - Figure 1)
i.
Proceed to Step 4.
4. Inspect the following areas, visually, for possible damage due to exhaust gas exposure:
RH washer hose, washer nozzle, EGR bypass vacuum actuator, EGR bypass vacuum line, and engine air inlet duct. Repair as necessary.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
MT102209
Use SLTS Operations If
Actual
Available; Claim Additional
Time
Diagnosis Or Labor
Performed As Actual Time
DEALER CODING
CONDITION
BASIC PART NO.
CODE
9E469
01
Disclaimer