F 550 2WD Super Duty V8-7.3L DSL Turbo VIN F (2002)
Water Pump: Service and Repair
Removal and Installation
1. Drain the cooling system.
2. Remove the cooling system fan and fan clutch.
3. Remove the accessory drive belt.
4. NOTE: The water pump pulley is removed for clarity.
Disconnect the heater hose from the water pump.
5. Remove the two bolts and the water outlet tube.
6. Disconnect the engine coolant temperature (ECT) sensor connector, if equipped.
7. Disconnect the camshaft position sensor electrical harness from the water pump.
1. Remove the bolt.
2. Disconnect the pin-type retainer and position the harness away from the water pump.