F 550 4WD Super Duty V10-6.8L (2009)
Keyless Entry Transmitter: Testing and Inspection
Remote Keyless Entry (RKE) Transmitter Programming
Remote Keyless Entry (RKE) Transmitter Programming
NOTE: All Remote Keyless Entry (RKE) transmitters must be programmed at the same time.
NOTE: Programming the RKE transmitters can be accomplished using a scan tool or by carrying out the following steps.
1. The vehicle must be electronically unlocked before entering the program mode using the RKE transmitter, keyless entry keypad (if equipped) or
door lock control switch while the driver door is open.
2. Turn the key from the OFF to the ON position 8 times within 10 seconds, with the eighth turn ending in the ON position. If the module
successfully enters program mode, the module locks and unlocks all the doors.
3. Within 20 seconds, press any button on an RKE transmitter and the doors lock and then unlock to confirm that the RKE transmitter is
programmed. Repeat this step for each RKE transmitter.
4. If the door locks do not respond for any RKE transmitter, wait several seconds and press the button again. If the door locks still fail to respond,
refer to Inspection and Verification. (Make sure that no more than the maximum number of RKE transmitters [4] are attempted to be programmed.
If 4 transmitters are programmed and an attempt is made to program an additional transmitter, the vehicle horn will sound indicating that the
maximum number of transmitters has already been programmed.)
5. Exiting the programming mode is accomplished if one of the following occurs:
-
The key transitions to the OFF position.
-
Twenty seconds have passed since entering programming mode or since the last RKE transmitter was programmed.
-
The maximum number of RKE transmitters has been programmed.
Autolock and Auto-Unlock Programming
Autolock and Auto-Unlock Programming
Programming the Autolock Feature Using the Door Lock Control Switch
NOTE: The autolock feature can be activated or deactivated independently of the auto-unlock feature.
NOTE: The autolock feature of the Smart Junction Box (SJB) can also be configured on or off with the scan tool. For additional information on module
configuration, refer to Information Bus.
NOTE: When programming the autolock feature using the door lock control switch method, the following steps must be carried out within 30 seconds or
the procedure will need to be repeated. If the procedure needs to be repeated, wait 30 seconds between programming sessions.
1. NOTE: Prior to beginning, make sure the ignition key is in the OFF position and all vehicle doors are closed.
Turn the ignition key from the OFF to the ON position.
2. Press the unlock button on the door lock control switch 3 times.
3. Turn the ignition key from the ON to the OFF position.
4. Press the unlock button on the door lock control switch 3 times.
5. Turn the ignition key to the ON position. The horn chirps once to indicate that programming mode is entered.
6. To enable/disable the autolock feature, press the unlock button on the door lock control switch then the lock button. The horn chirps once if the
autolocks are disabled or twice (one short chirp followed by a long chirp) if the autolocks are enabled.
7. Turn the ignition key to the OFF position. The horn chirps once to signal that the programming is complete.
Programming the Autolock Feature Using the Keyless Entry Keypad
