F 550 4WD Super Duty V10-6.8L (2009)
Rear Door Hinge: Adjustments
Door Alignment - Rear, SuperCab
Door Alignment - Rear, SuperCab
NOTE: The following procedure is for carrying out fore, aft, up, down and tilt adjustments.
1. Remove the rear door inside trim panel(s).
2. NOTE: Left rear door shown, right rear door symmetrically opposite.
Remove the upper door strikers.
3. Remove the lower door strikers.
4. Loosen the bolts only enough to allow for slight door movement.
5. Close the doors and carefully adjust the rear door until correctly aligned with all bodylines and adjacent panels.
6. Carefully open the doors and tighten the bolts.
-
Tighten to 30 Nm (22 lb-ft).