F 550 4WD Super Duty V10-6.8L (2009)
5. Remove the safety belt anchor bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
6. Remove the B-pillar trim panel.
-
Route the front safety belt and the shoulder belt guide through the B-pillar trim panel.
7. NOTICE: To avoid damage to the B-pillar trim panel, remove any retaining clips from the body and attach them to the B-pillar trim
panel before installing.
To install, reverse the removal procedure.
B-Pillar Trim Panel - SuperCab
B-Pillar Trim Panel - SuperCab
Removal and Installation
NOTE: Left side shown, right side similar.
1. Remove the rear seat backrest.
2. Remove the door opening scuff plate trim panel.
-
Remove the pushpin retainer.
-
Lift the door opening scuff plate trim panel upward to release the retaining clips.
3. Position aside the rear door opening weatherstrip.
4. NOTE: Inspect the shoulder safety belt guide and cover for damage. If the shoulder safety belt guide or cover is damaged or the cover does not
remain closed, install a new shoulder safety belt guide.