F 550 4WD Super Duty V10-6.8L (2009)
1. Remove the seat backrest. For additional information, refer to Seat Backrest - Front, Bench See: Front Seats/Seat Backrest - Front, Bench.
2. Remove the latch handle clip and latch handle on the side of the affected recliner.
3. Release the J-clip and invert the backrest trim cover up, on the affected recliner side.
4. NOTE: LH shown, RH similar.
Position the backrest foam pad up on the side of the affected recliner enough to remove the recliner cover.
-
Remove the recliner cover.
5. Remove the affected recliner-to-backrest frame bolts.
-
To install, tighten to 50 Nm (37 lb-ft).
6. Separate the affected recliner from the recliner torque shaft and remove the affected recliner.
7. To install, reverse the removal procedure.
Seat Recliner - Front, Bucket Seat
Seat Recliner - Front, Bucket Seat
Removal and Installation
1. Remove the front seat. For additional information, refer to Seat - Front, Bucket Seat See: Service and Repair/Front Seats/Seat - Front, Bucket Seat
.
2. If equipped, remove the manual lumbar handle.
1. Locate the slot in the manual lumbar handle.
2. Pry at 90 degrees of each side of the slot to release the tabs.
-
Remove the manual lumbar handle.
3. Release the clip and slide the recliner handle cover off.