F 550 4WD Super Duty V10-6.8L (2009)
Seat Backrest - Rear, Crew Cab, Bench Seat
Seat Backrest - Rear, Crew Cab, Bench Seat
Removal and Installation
1. Remove the rear seat. For additional information, refer to Seat Backrest - Rear, Crew Cab, Bench Seat.
2. Separate the cushion trim cover hook-and-loop strip on each side at the rear of the seat.
3. Pull the cushion trim cover away enough on each side to access the latch-to-cushion frame bolts.
4. Remove the latch-to-cushion frame bolts and backrest assembly.
-
To install, tighten to 50 Nm (37 lb-ft).
5. To install, reverse the removal procedure.
Seat Backrest - Rear, Crew Cab, Bucket Seat
Seat Backrest - Rear, Crew Cab, Bucket Seat
Removal and Installation
1. Remove the affected seat. For additional information, refer to Seat - Rear, Crew Cab, Bucket Seat See: Service and Repair/Rear Seats/Seat - Rear,
Crew Cab, Bucket Seat.
2. Remove the manual lumbar handle.
1. Locate the slot in the manual lumbar handle.
2. Pry at 90 degrees of each side of the slot to release the tabs.
-
Remove the manual lumbar handle.
3. Release the clip and slide the recliner handle cover off.
4. Release the clips, slide forward and separate the cushion side shield insert.
