F 550 4WD Super Duty V10-6.8L (2009)
26. Remove the 6 radiator upper support bolts and the engine cooling module.
Installation
1. Position the engine cooling module into the vehicle and install the 6 upper radiator support bolts finger-tight.
2. Tighten the 4 radiator support top bolts.
-
Tighten to 40 Nm (30 lb-ft).
3. Tighten the 2 radiator support front bolts.
-
Tighten to 63 Nm (46 lb-ft).
4. Position the lower air deflector and install the 3 pushpin retainers.
5. Connect the position retainer and transmission auxiliary cooler tube quick connect couplings and install the secondary latches.
6. Using a new gasket seal and new O-ring seals, connect the A/C compressor-to-condenser tube to the condenser and install the nut.
-
Tighten to 15 Nm (133 lb-in).
7. Using a new gasket seal and new O-ring seals, connect the condenser outlet tube to the condenser and install the nut.
-
Tighten to 15 Nm (133 lb-in).
8. Install the RH air deflector pushpin retainer.
9. If equipped with 4WD, position the 4WD differential vacuum valve and install the bolt.
-
To install, tighten to 8 Nm (71 lb-in).
10. Position the engine compartment wiring harness and connect the 4 wiring harness position retainers to the cooling fan shroud.
11. Connect the lower radiator coolant hose quick connect coupling and install the locking clip.
12. Press the engine cooling fan lower shroud position retainer and rotate the lower fan shroud down until the 4 position retaining tabs lock into
position.
13. Connect the degas bottle coolant inlet hose position retainer to the cooling fan shroud.
14. Connect the degas bottle coolant inlet hose to the radiator.
15. Position the power steering reservoir and install the 2 bolts.
-
To install, tighten to 7 Nm (62 lb-in).
16. Connect the upper radiator coolant hose quick connect coupling and install the locking clip.
17. Position the power steering fluid cooler and install the 2 bolts.
-
Tighten to 11 Nm (97 lb-in).
18. Install the power steering fluid cooler hose retainer onto the radiator.
19. Install the LH air deflector pushpin retainer.
