F 550 4WD Super Duty V10-6.8L (2009)
8. NOTE: RH shown, LH similar.
Remove the 4 exhaust Y-pipe flange nuts.
9. Remove and discard the 2 transmission mount-to-crossmember nuts.
RH engine support insulator
10. Remove the A/C compressor.
11. Remove the starter.
12. Remove and discard the RH engine support insulator through bolt.
13. Loosen the LH engine support insulator through bolt.
14. Loosen the 3 LH engine support insulator nuts.
15. Remove and discard the 4 RH engine support insulator nuts.
LH engine support insulator
16. Remove the oil cooler. For additional information, refer to Oil Cooler See: Engine Lubrication/Oil Cooler/Service and Repair.
17. Loosen the RH engine support insulator through bolt.
18. Remove and discard the LH engine support insulator through bolt.
19. Loosen the 4 RH engine support insulator nuts.
-
Discard the 4 nuts.
20. Remove and discard the 3 LH engine support insulator nuts.
All engine support insulators
21. Using the Engine Support Bar, Support Hook and Engine Support Bracket, raise the engine.