F 550 4WD Super Duty V10-6.8L (2009)
15. NOTICE: Only use hand tools when installing the engine support through bolt or damage to the engine support insulator may occur.
Install a new RH engine support insulator through bolt.
-
Tighten to 350 Nm (258 lb-ft).
16. Install the starter.
17. Install the A/C compressor.
All vehicles
18. NOTICE: Only use hand tools when installing the transmission mount-to-crossmember nuts or damage to the transmission mount may
occur.
Install 2 new transmission mount-to-crossmember nuts.
-
Tighten to 115 Nm (85 lb-ft).
19. NOTE: RH shown, LH similar.
Install the 4 exhaust Y-pipe flange nuts.
-
Tighten to 40 Nm (30 lb-ft).
20. Install the engine cooling fan.
21. Install the generator.
22. Install the TB spacer.
23. Install the ACL outlet pipe.
24. Connect the battery ground cable.