F 550 4WD Super Duty V10-6.8L (2009)
4. Connect the TP sensor and ETC electrical connectors.
5. Connect the engine wiring harness position retainers to the intake manifold.
6. Connect the engine vacuum hose connections to the rear of the intake manifold.
7. Connect the wiring harness and vacuum harness retainers to the rear of the intake manifold.
8. Connect the PCV tube quick connect coupling to the intake manifold.
9. Position the EVAP tube and connect the quick connect coupling to the intake manifold.
10. Connect the 2 heated PCV coolant hoses to the intake manifold.
11. Connect the 10 fuel injector electrical connectors.
12. Connect the fuel rail pressure and temperature sensor electrical connector and vacuum connector.
13. Connect the IMRC actuator electrical connector.
14. Connect the fuel supply spring lock coupling to the fuel rail.
15. Connect the heater coolant hose to the coolant crossover assembly.
16. Connect the heated PCV coolant hose to the coolant crossover assembly.
17. Connect the upper radiator hose to the thermostat housing.
18. Position the crankcase ventilation tube and connect the quick connect coupling.
19. Install the generator.
20. Install the ACL outlet pipe.
21. Fill and bleed the engine cooling system.
