F 550 4WD Super Duty V10-6.8L (2009)
Power Steering Line/Hose: Service and Repair
Power Steering Pump to Steering Gear Pressure Line
Power Steering Pump to Steering Gear Pressure Line
Removal and Installation
NOTICE: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power
steering components may result.
1. Using a suitable suction device, drain the power steering fluid reservoir.
2. With the vehicle in NEUTRAL, position it on a hoist.
3. Remove the pressure line bracket/pump bolt.
-
To install, tighten to 25 Nm (18 lb-ft).
4. Disconnect the pressure line-to-pump fitting.
-
To install, tighten to 35 Nm (26 lb-ft).
5. Disconnect the steering gear shield from the line fitting and position the shield up on the lower steering column shaft.
6. Disconnect the return hose-to-steering gear fitting.
-
Discard the O-ring seal.
-
To install, tighten to 35 Nm (26 lb-ft).