F 550 4WD Super Duty V10-6.8L (2009)
Air Bag Control Module: Service and Repair
Restraints Control Module (RCM)
Removal and Installation
WARNING: If a vehicle has been in a crash, inspect the restraints control module (RCM) and the impact sensor (if equipped) mounting areas
for deformation. If damaged, restore the mounting areas to the original production configuration. A new RCM and sensors must be installed
whether or not the air bags have deployed. Failure to follow these instructions may result in serious personal injury or death in a crash.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE: Carrying out Programmable Module Installation (PMI) will not enable the 911 assist option that is disabled. The RCM and Accessory Protocol
Interface Module (APIM) must be configured correctly to fully support 911 assist functionality. See: Powertrain Management/Computers and Control
Systems/Information Bus/Testing and Inspection/Programming and Relearning
1. When installing a new RCM, carry out the appropriate steps necessary for the Programmable Module Installation (PMI) procedure. See:
Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
2. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering.
3. If equipped, remove the following front seat(s):
-
20 percent seat
-
bench seat
