F 550 4WD Super Duty V10-6.8L (2009)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Front
Wheel Speed Sensor - Front, Four Wheel Drive (4WD)
Removal and Installation
1. Remove the disc brake shield.
2. Disconnect the wheel speed sensor electrical connector.
3. Detach the wheel speed sensor harness from the radius arm.
4. Remove the 3 wheel speed sensor harness bolts.
-
To install, tighten to 15 Nm (133 lb-in).
5. Remove the wheel speed sensor bolt and the sensor.
-
To install, tighten to 18 Nm (159 lb-in).
6. NOTICE: Make sure the wheel speed sensor harness is correctly routed to prevent the brake disc from damaging the harness.
To install, reverse the removal procedure.