F 550 4WD Super Duty V10-6.8L (2009)
13. Inspect the output shaft and park gear for damage.
1. Inspect the park gear for damage.
2. Inspect the OSS gear for damage.
14. If damage is found to either the OSS or park gears, remove the park gear and output shaft as an assembly.
15. NOTE: The park gear and OSS gear may be present on the output shaft.
Remove the park and OSS gear from the output shaft.
16. Inspect the Teflon(R) seals in the rear of the case. If the seals are worn or damaged, install new scarf cut seals.
Installation
All vehicles
1. Using petroleum jelly to hold the bearing or bushing in place, install the output shaft bearing for slip flange models and the bushing for fixed yoke
models.
