F 550 4WD Super Duty V10-6.8L VIN D (2004)
Position the oil pan gasket and the oil pan in the vehicle from the rear of the engine.
2. Install the oil pump screen and pickup tube.
1
Install and tighten the spacer.
2
Insert the oil pump screen pickup tube into the oil pump and position the support bracket over the spacer.
3
Install and tighten the bolts.
3. NOTE: If not secure within four minutes, the sealant must be removed and the sealing area cleaned. To clean the sealing area, follow the
directions provided on the packaging of the silicone gasket remover and the metal surface prep. Failure to follow this procedure can cause future
oil leakage.
Apply a bead of silicone gasket and sealant where the front cover and rear crankshaft seal retainer fit to the engine block.
