F 550 4WD Super Duty V10-6.8L VIN D (2004)
6. NOTE: Slightly loosen the Camshaft Holding Tool to allow slight camshaft movement.
Preposition the camshafts.
1
Rotate the LH camshaft with the Camshaft Positioning Tool until the timing mark is approximately at 12 o'clock.
2
Rotate the RH camshaft with the Camshaft Positioning Tool until the timing mark is approximately at 11 o'clock.
^
Tighten the Camshaft Holding Tool to maintain camshaft prepositioning.
7. CAUTION: Rotate the crankshaft counterclockwise only. Do not rotate past the position shown or severe piston and/or valve damage can occur.
Position the crankshaft with the special tool, then remove the tool.
8. Install the crankshaft sprocket, marking sure the flange faces forward.