F 550 4WD Super Duty V10-6.8L VIN D (2004)
1. For vehicles equipped with a circular flange, align the index marks and connect the front driveshaft to the transmission. Install the new bolts.
Hand-tighten only; do not tighten at this time.
2. For vehicles equipped with a slip yoke, align the index marks and slide the driveshaft slip yoke onto the output shaft.
3. Position the center support bearing and install the bolts. Hand-tighten only; do not tighten at this time.
4. Tighten the driveshaft to transmission flange bolts and the driveshaft center bearing bolts.
