F 550 4WD Super Duty V10-6.8L VIN S (2000)
6. Disconnect the condenser-to-evaporator line from the A/C condenser core and remove the line.
INSTALLATION
1. To install, reverse the removal procedure.
^
Lubricate the O-ring seals with PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN-12-C) or equivalent
meeting Ford specification WSH-M1C231-B.
Evaporator Inlet Line
REMOVAL
CAUTION: It may be necessary to cut the underbody auxiliary line(s) being serviced into sections to facilitate removal. Make sure to correctly identify
the line(s) being serviced before carrying out any cutting of the line(s).
NOTE: Lay out the new lines in vehicle position to assist in the installation.
1. Discharge and recover the refrigerant. Refer to: Heating and Air Conditioning, Service and Repair, Refrigerant Discharging and Recovery
Procedure, See: Service and Repair/Refrigerant Discharging and Recovery procedure
2. Raise and support the vehicle.
3. Remove the front and rear RH wheels.
4. Remove the four screws, three bolts, and three pin- type retainers for the fender splash shield.
5. Remove the vacuum reservoir retaining nuts.
