F 550 4WD Super Duty V10-6.8L VIN S (2000)
2. Install the second retaining ring.
-
Make sure the ring is firmly seated in the groove in the housing.
3. NOTE: A dab of grease applied to the small diameter of the washer will hold it in place during installation of the seal.
Install the washer into the side cover side of the housing seal bore with the small diameter piloted into the retaining ring.
4. Assemble a new seal onto Bearing and Seal Tool, so the lip with the garter spring is toward the shoulder of the tool.
5. Working from the side cover side of the housing, pilot the seal tool into the washer and bearing and press with a force of 445-3,560 N (100-800
lb) until the seal is seated against washer.
