F 550 4WD Super Duty V10-6.8L VIN S (2000)
Remove the clutch hydraulic system from the vehicle.
13. Clean the clutch hydraulic system components to prevent contaminants from entering the hydraulic system.
14. CAUTION: Place a suitable container under the clutch master cylinder.
Disconnect the hydraulic tube from the clutch master cylinder.
1. Using a 3/32-inch punch and a hammer, drive out the roll pin, and discard it.
2. Disconnect the hydraulic tube from the clutch master cylinder.
15. Note: Sometimes the O-ring seal will remain inside the clutch master cylinder.
Remove the O-ring seal from the end of the hydraulic tube, and discard it. Cap the open end of the hydraulic tube.
Installation
Bleeding Procedure See: Manual Transmission/Transaxle/Service and Repair/Manual Transaxle/Transmission and Clutch
1. CAUTION: The push rod is not removable after installing it in the clutch master cylinder.
Install the new push rod in the clutch master cylinder.
2. CAUTION: Place a suitable container under the clutch master cylinder.
