F 550 4WD Super Duty V10-6.8L VIN S (2000)
CAUTION: Place a wood block between the pry bar and the rear axle housing to protect the machined surface from damage.
Use the pry bar and the wood block to remove the differential case from the rear axle housing.
9. Remove the ring gear bolts.
10. CAUTION: Care should be taken not to damage the ring bolt hole threads.
Note: The anti-lock speed sensor ring cannot be reused once removed.
Insert a punch in the bolt holes. Drive off the ring gear and, if necessary, the anti-lock speed sensor ring.
11. Install the differential case without the ring gear.
1. Position the differential case assembly, including bearing clips and shims, in the housing.
2. Install the differential bearing caps.
