F 550 4WD Super Duty V10-6.8L VIN S (2000)
5. NOTE: Wrap electrical tape around the bearing cups to prevent them from failing off the U-joint spider.
Remove the front driveshaft.
^
Compress and separate the front driveshaft from the front axle, then separate the driveshaft from the transfer case.
Installation
1. NOTE: Install the front driveshaft with the index marks aligned.
NOTE: An extension must be used to tighten the driveshaft to transfer case bolts. Extensions change the calibration of the torque wrench. Use the
torque wrench manual to calculate the correct settings.
NOTE: Install new bolts and retainers.
To install, reverse the removal procedure.
