F 550 4WD Super Duty V10-6.8L VIN S (2000)
Note:
^
Inspect the transmission and axle seals for damage. Replace as necessary.
^
Lubricate the slip yoke spline with Premium Long-Life Grease XG-1-C or equivalent meeting Ford specification ESA-M1C75-13.
^
Install the driveshaft so that the index marks made before removal are aligned or the yellow mark on the driveshaft tube is in line with the
yellow mark on the rear axle flange.
^
Prior to the third removal, clean the bolt threads and apply Loctite(R) 242 or equivalent.
Follow the removal procedure in reverse order.
Rear, One-Piece, 4X4 With 137-,141- and 142-Inch Wheel Base
Removal
1. Raise and support the vehicle.
2. Index mark the rear driveshaft to the rear axle flange and at the transfer case flange.
