F 550 4WD Super Duty V8-6.0L DSL Turbo VIN P (2003)
5. Disconnect the heated seat switch electrical connector.
All seats
6. Remove the side trim cover.
NOTE: Note the seat control switch wire harness routing for installation.
7. Remove the seat backrest trim panel.
1
Using a pin-type retainer removal tool, release the two pin-type retainers at the bottom of the seat backrest trim panel (see inset for location).
2
Push the sides of the seat backrest trim panel together and release the retaining clips (see inset for location).
3
Slide the seat backrest trim panel down, releasing the upper retainers and remove the seat backrest trim panel.
8. Release the seat backrest trim cover J-clips.