F 550 4WD Super Duty V8-6.4L DSL Turbo (2008)
1. NOTE: Apply clean engine oil to the O-ring seals.
Inspect and clean both spring lock coupling ends. Install new O-ring seals and garter springs if necessary.
2. NOTE: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the tube.
Fit the male end into the female end and push until the garter spring snaps over the flared end of the female end.
3. Make sure the spring lock coupling is engaged by pulling on the tubes.
4. Install the fuel tube safety clip.
5. Connect the battery ground cable.
Disconnect - Type II
WARNING:
-
Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly
