F 550 4WD Super Duty V8-6.4L DSL Turbo (2008)
4. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is
snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the sector lever
cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull
back on the selector lever cable end to make sure that the end is correctly installed.
NOTE: To prevent selector lever cable damage, do not apply force to the selector lever cable assembly between the manual control lever and the
selector lever cable bracket.
Connect the selector lever cable onto the manual control lever.
5. Push the rubber grommet and selector lever cable up through the floor pan.
6. Connect the cable pushpin onto the stud on the dash panel.
7. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is
snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the sector lever
cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull
back on the selector lever cable end to make sure that the end is correctly installed.
NOTE: To prevent selector lever cable damage, do not apply force to the selector lever cable assembly between the selector lever arm ball stud
and the steering column bracket.
