F 550 4WD Super Duty V8-6.4L DSL Turbo (2008)
4. Lift the tab twisting the bulkhead connector, push it through the solenoid body and remove the wire harness.
Installation
1. Push the bulkhead connector through the transmission solenoid body, twist it to lock it in place.
2. Connect the internal wiring harness.
1. Install the 2 screws.
2. Connect the TFT sensor electrical connector.
3. Connect the solenoid electrical connectors.
3. NOTE: The O-ring seal must be installed in the top slot.
Install a new solenoid body bulkhead connector O-ring seal and lubricate it with clean automatic transmission fluid.
