F 550 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
Brake Caliper: Service and Repair
Front
Caliper Removal and Installation
Removal
WARNING: Asbestos fiber dust may be present on brake and clutch assemblies and is hazardous to health if inhaled.
WARNING: Brake and clutch assemblies should be cleaned using a vacuum cleaner recommended for use with asbestos fibers such as
brake/clutch/service vacuum. The bag must be labeled per OSHA instructions, sealed, and the trash hauler notified as to the bag's contents.
WARNING: If a vacuum suitable for asbestos is not available, cleaning should be done wet. If dust generation is still possible, technicians
should wear government-approved toxic dust purifying respirators.
WARNING: Occupational Health And Safety Act (OSHA) requires areas where asbestos dust generation is possible to be isolated and posted
with warning signs. Only technicians performing brake or clutch repair should be present in the area.
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally,
drink water and induce vomiting. Get medical attention immediately.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, wash it with water
immediately.
Disconnect the brake hose.
1
Remove the brake hose bolt.
2
Disconnect the brake hose
3
Remove and discard the copper washers. Plug the brake hose.
4. Remove the disc brake caliper
1
Remove the disc brake caliper pin bolts.
2
Lift the disc brake caliper from the disc brake caliper anchor plate
