F 550 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
5. Insert the shim between the rear spring and the spring seat.
-
Position the shim so the tie bolt through the spring leaves is in the shim recess, the stud on the bottom of the shim is in the spring seat recess,
and the shim is aligned with the rear spring.
6. Install two new U-bolts and four new nuts.
7. Remove the support from the axle.
8. Lower the vehicle.
Lean Correction - Motorhome
Lean Correction - Motorhome
1. CAUTION: Corrections should not be attempted on vehicles with a bumper-to-ground height right-to-left variation of 25.4 mm (1 inch) or less.
Corrections should not be made if the ride height variation is 12.7 mm (1/2 inch or less).
Raise and support the vehicle.
2. Position a separate support for the front axle.
3. Raise the front axle to relieve front spring tension.
