F 550 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
18
CAUTION: The input shaft seal must be square in the seal bore and installed to the correct depth.
Assemble Input Seal installer Tool, small diameter end first, over the input shaft and against the seal and tap the tool until the tool shoulder is
squarely against the valve housing.
-
This will correctly position the seal in the housing bore just beyond the retaining ring groove.
19. Remove any seal material that may have sheared off and is in the seal bore and retaining ring groove.
20. Insert the new retaining ring into its groove in the valve housing
Steering Gear Housing Roller Bearing or Retaining Ring Replacement - Motorhome
Steering Gear Housing Roller Bearing or Retaining Ring Replacement - Motorhome
Disassembly
NOTE: The following tools are available from Kent-Moore Tool Division, 29784 Little Mack, Roseville, MI 48066. Bearing and Seal Tool
(TAS4O) J37071.
1. CAUTION: The bearing must be pressed out from the side cover side to protect the seal counterbore. Be sure to use a bearing removal tool that
will clear the retaining ring.
Place the bearing removal end of Bearing and Seal Tool against the side cover end of the bearing and press the roller bearing out of the trunnion
end of the bearing bore if it needs replacing. Discard the bearing.
