F 550 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
Tighten the nut.
^
Use the special tool to prevent the flange from turning while tightening the nut. Remove the special tool when taking pinion bearing torque
preload readings.
^
Take frequent pinion bearing torque preload readings.
^
The final reading must be 0.56 Nm (5 inch lbs.) more than the initial reading taken during removal.
4. Connect the front driveshaft to the front axle flange.
1
Remove the tape from the bearing cups.
2
Connect the front driveshaft to the front axle flange.
3
Install the two new retainers and four new bolts.
5. Check and, if necessary, fill the axle with the specified lubricant.
6. Lower the vehicle.
