F 550 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
5. Position the rear driveshaft assembly and install the center support bearing bolts.
^
Hand-tighten only; do not tighten at this time.
6. Connect the rear driveshaft assembly to the front driveshaft. Install the new retainers and bolts.
7. Connect the rear driveshaft assembly to the rear axle. Install the new retainers and bolts.
8. Tighten the driveshaft center support bearing bolts.
Driveshaft - Rear, Three-Piece, Motorhome
Driveshaft - Rear, Three-Piece, Motorhome
Removal
1. Raise and support the vehicle.
