F 550 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
3. Position the ABS sensor and install the bolt.
All vehicles
4. Position the brake disc shield.
5. NOTE: Apply a coat of Ford High Temperature 4x4 Front Axle and Wheel Bearing Grease E8TZ-19590-A meeting Ford specification
ESA-MIC198-A to the O-ring area of the wheel hub and bearing before installing the hub and bearing.
Install the wheel hub and bearing.
1. Position the wheel hub and bearing.
2. Install the four lock nuts.
Vehicle equipped with ABS
6. NOTE: The following step applies only to vehicles equipped with ABS.
Connect the ABS sensor harness.
1. Position the ABS sensor harness and install the routing clips.
2. Connect the harness connector.
All vehicles
7. CAUTION: The non-metallic thrust washer must be installed between the two metal thrust washers. Failure to do so will cause severe wear to the
non-metallic thrust washer, allowing the axle shaft to travel further in and out during torque thrust causing damage to the wheel hub and bearing,
the axle shaft end seal and the axle shaft.
