Festiva L4-81 1.3L SOHC (1988)
equivalent.
6. Remove five screws from lower steering column cover, and remove upper and lower steering column covers.
7. Release wiring harness clip and unplug four harness connectors from the back of the combination switch.
8. From below the steering column, loosen band clamp securing switch hub to steering column jacket.
9. Pull combination switch assembly off the steering column.
10. Remove screws securing instrument cluster bezel and move bezel rearward, Fig. 27.
11. Disconnect switch electrical connectors from switches on instrument cluster bezel, then remove instrument cluster bezel.
12. Disconnect speedometer cable transaxle, then remove four screws securing instrument cluster.
13. Move cluster rearward and disconnect cluster electrical wiring.
14. Disconnect speedometer cable from the instrument cluster, then remove instrument cluster from the vehicle.
15. Remove spacer brace bolts under the steering column, Fig. 28, then remove spacer brace.
16. Remove left and right heater ducts, Fig. 29.
17. Remove screws securing glove box hinges to the glove box, then the glove box.
18. Remove cover from fuse panel, then the screws securing fuse panel.
19. Push the fuse panel forward but do not remove fuse panel.
20. Remove shift lever knob then the console attaching screws. Fig. 30. Remove only three screws shown in the figure. The remaining screws
secures the console stiffener bracket.
21. Remove the center console.
22. Remove radio and heater-A/C control bezel attaching screws.
23. Remove two screws securing radio to instrument panel.
24. Pull rearward and disconnect antenna lead and wiring connectors.
25. Remove rubber mounting insulator from the radio ground stud.
26. Remove nut and radio ground wire from ground stud.
27. Remove radio from the vehicle.
28. Remove four heater-A/C control assembly attaching screws.
29. Reaching through the glove box opening, disconnect recirc/fresh air door cable at the door operating lever, Fig. 31.
30. Disconnect mode selector cable at function control lever, Fig. 32.
31. Disconnect temperature control cable from control lever.
32. Pull control assembly away from instrument panel, then disconnect blower motor and illumination lamp wiring connectors.
33. Remove snap in trim inserts concealing the instrument panel attaching bolts, Fig. 33.
34. Remove seven instrument panel attaching bolts and two attaching nut, Fig. 34.
35. Disconnect any remaining electrical connectors, and remove instrument panel.
36. Reverse procedure to install.
