Festiva L4-81 1.3L SOHC (1988)
7.
Remove the carburetor vacuum port hose from the orange No. 1 port of the EGR vacuum modulator. Connect the hose removed from the
modulator to the EGR valve nipple. See Figure 2.
8.
Install the second vacuum cap included in the kit on the EGR vacuum modulator orange No. 1 port nipple.
9.
Remove and throw away the distributor vacuum advance. Refer to the Festiva Shop Manual, Section 23-02, for removal information.
10.
Install the new distributor vacuum advance included in the kit. Refer to the Festiva Shop Manual, Section 23-02 for installation information.
11.
Open kit E9PZ-12370-B and remove the contents. The VECI label to be used on this vehicle has the ID number DX07 (1988 California) in the
lower left corner. The other VECI label (DX08) included in the kit should be discarded.
12.
Clean the surface of the existing VECI label with alcohol. Install the new VECI label over the existing label. Use a squeegee to work out any
bubbles and make sure there is adequate adhesion to the old label.
Figure 1
13.
Remove the distributor vacuum advance manifold port hose from the intake manifold port. Cap the open intake manifold port with the vacuum cap
provided in the special service kit. See figure 1.
14.
Cut the manifold vacuum hose that goes to the map sensor just to the carburator side of the routing bracket as shown in Figure 1.
15.
Insert the "T" provided in the kit into the vacuum hose and install the distributor vacuum advance hose, removed from the intake manifold port in
step 13, to the open port on the "T".
16.
Remove and plug the vacuum advance hoses at the distributor vacuum advance. Set the initial ignition timing to 2 ~ BTDC.
17.
Unplug and reconnect the distributor vacuum advance hoses.
18.
Check and, if necessary, reset the curb idle and the fast idle speeds. Refer to the Festiva Shop Manual, Section 24-16, for detailed instructions and
specifications.
