Festiva L4-81 1.3L SOHC EFI (1989)
Figure 2
5.
Check the repair by testing the seat travel.
a.
Move the seat cushion as far back as it will go.
b.
Make note of a reference point like the rear edge of the seat release handle.
c.
Mark the rocker panel with chalk at this point.
d.
Measure forward 6 inches (150 mm) and make another chalk mark.
e.
Test the seat travel by lifting the seat back recline release lever or gently pressing down on the foot release lever, see Figure 2.
f.
Repeat this test three times to make sure the results are consistent.
Figure 1
6.
If the seat travel does not meet the above specification, continue with Steps 7 through 14.
7.
Loosen the three bolts and one nut that hold the seat tracks to the floor pan, Figure 1.
8.
Move the seat to the full forward and full rear positions three times to equalize the tracks.
9.
Tighten the three bolts and one nut, Figure 1, to 15-20 lb-ft (20-27 N-m) in the following order.
a.
Left front
b.
Right front
c.
Right rear
