Festiva L4-81 1.3L SOHC EFI (1989)
10.
Place front shell in a vise, then install front shell return spring.
11.
Place rear shell onto front shell noting alignment marks.
12.
Rotate rear shell clockwise until rear shell locks into place with front shell.
13.
Install dust boot onto rear shell then install clevis onto valve rod and plunger assembly.
14.
Install master cylinder.
Bendix, Teves & Double Diaphragm Booster
On Bendix, Teves and Double Diaphragm Booster type power brake units, overhaul is not required. If it has been determined that the brake booster is
defective, replace power brake unit as an assembly. In some instances, the only service required is replacement of the check valve and grommet and
pushrod adjustment.
