Festiva L4-81 1.3L SOHC EFI (1989)
Ignition Coil: Service and Repair
Removal
1.
Disconnect the battery negative cable.
2.
Pull the coil secondary lead off the coil tower, being careful to pull on the connector boot and not the wire.
3.
Pull the ECA and ignition module primary connectors off the coil primary ground terminal tabs.
4.
Push back the primary positive terminal boot and disconnect the ignition module suppression capacitor and battery positive leads.
5.
Loosen the mounting bracket clamp screw until the coil is free to slide out.
Ignition Coil
Installation
1.
Slide the coil into the mounting bracket while positioning the primary terminals for convenient connection tighten the mounting bracket clamp
screw.
2.
Connect the battery positive, suppression capacitor and ignition module positive leads to the coil primary "+" terminal. Cap the terminal with the
insulating boot.
3.
Push the ECA and ignition module ground connectors onto the primary ground terminal tabs.
4.
Plug the coil secondary lead into the coil tower, using firm pressure for a tight boot seal.
5.
Connect the battery negative cable.
