Festiva L4-81 1.3L SOHC EFI (1989)
4.
Clean the surface of the existing VECI label with alcohol. Install the new VECI label over the existing label. Use a squeegee to work out any
bubbles and make sure there is adequate adhesion to the old label.
Figure 1
5.
Remove the distributor vacuum advance manifold port hose from the intake manifold port. Cap the open intake manifold port with the vacuum cap
provided in the special service kit. See Figure 1.
6.
Cut the manifold vacuum hose that goes to the map sensor just to the carburator side of the routing bracket as shown in figure 1.
7.
Insert the "T" provided in the kit into the vacuum hose and install the distributor vacuum advance hose, removed from the intake manifold port in
step 5, to the open port on the "T".
8.
Remove and throw away the distributor vacuum advance. Refer to the Festiva Shop Manual, Section 23-02, for removal information.
9.
Install the new distributor vacuum advance (E9BZ-12370-C). Refer to the Festiva Shop Manual, Section 23-02, for installation information.
10.
Remove and plug the vacuum advance hoses at the distributor vacuum advance. Set the initial ignition timing to 2~ BTDC.
11.
Unplug and reconnect the distributor vacuum advance hoses.
12.
Check and, if necessary, reset the curb idle and the fast idle speeds. Refer to the Festiva Shop Manual, Section 24-16, for detailed instructions and
specifications.
Obtain an Authorized Modifications Decal and list the date, dealer number, and summary of alterations performed. Select a prominent place adjacent to
the Vehicle Emission Control Information Decal suitable for installing the Authorized Modifications Decal. Clean the area, install the decal, and cover it
with a clear plastic decal shield.
1988 - 49 State Calibrated Vehicles
1.
Obtain special service kits E8PZ-12370-A and E9PZ-12370-A.
