Festiva L4-81 1.3L SOHC EFI (1989)
Obtain an Authorized Modifications Decal and list the date, dealer number, and summary of alterations performed. Select a prominent place adjacent to
the Vehicle Emission Control Information Decal suitable for installing the Authorized Modifications Decal. Clean the area, install the decal, and cover it
with a clear plastic decal shield.
1989 - California Calibrated Vehicles
1.
Obtain special service kits E8PZ-12370-B and E9PZ-12370-B.
2.
Open kit E8PZ-12370-B and remove the contents. Throw away the VECI label and instruction sheet. The number in the lower left corner of the
VECI label is DX05.
3.
Remove the EGR valve and throw away the steel gasket between the EGR valve and the intake manifold.
4.
Install the new blind EGR gasket included in the special service kit between the EGR valve and the intake manifold.
Figure 2
5.
Remove and throw away the vacuum hoses and the green and black EGR delay valve between the EGR valve and the No. 1 EGR solenoid. See
Figure 2.
6.
Install one of the vacuum caps included in the kit on the No. 1 EGR solenoid nipple.
7.
Remove the carbufetor vacuum port hose from the orange No. 1 port of the EGR vacuum modulator. Connect the hose removed from the
modulator to the EGR valve nipple. See Figure 2.
8.
Install the second vacuum cap included in the kit on the EGR vacuum modulator orange No. 1 port nipple.
9.
Remove and throw away the distributor vacuum advance. Refer to the Festiva Shop Manual, Section 23-02, for removal information.
10.
Install the new distributor vacuum advance included in the kit. Refer to the Festiva Shop Manual, Section 23-02, for installation information.
