ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Camshaft > < Crankshaft Front Seal

Fiesta 1996 (08.1995-02.2002)

Engine - 1.25L/1.4L Zetec-SE (Sigma)/1.6L - Valve Seals Fiesta 1996 (08/1995-02/2002)
In-vehicle Repair

Special Tool(s)

Installer, valve stem oil seals

303-037 (21007A)

Compressor, valve spring

303-361 (21155)

Adapter for 303 - 361

303-361-04 (2115504)

Adapter for 303 - 361

303-361-05 (2115505)

Installer, valve collets

303-362 (21156)

Connector, air supply (cylinder head)

303-363 (21157)

Pliers, valve stem seals

303-508 (21211)
Materials
Name
Specification
Engine oil
WSS - M2C912 - A1 

Removal

  1. Remove the camshafts.
    For additional information, refer to Camshafts in this section.

  1. Remove the ignition coil (four bolts).

  1. Fit the special tools.
    • Apply compressed air (7-10 bar) to the cylinder being worked on.

  1. Remove the valve spring using the special tool.
    • Compress the valve spring.
    • Take out the valve collets, valve spring retainer and valve spring.

  1. Remove the valve stem seal using the special tool.
  1. Repeat the previous steps on all the other valves.

Installation
  1. Push the valve stem seal fitting sleeve onto the valve stem.

  1. CAUTION:
    CAUTION:The valve stem seals for the inlet valves are green, those for the exhaust valves are brown.
    Install the valve stem seal.
    • Lubricate the valve stem and valve stem seal lip with engine oil .
    • Slide the valve stem seal onto the valve stem with the special tool.

  1. Install the valve spring using the special tool.
    • Compress the valve spring using the special tool and pull the valve stem seal fitting sleeve from the valve stem.
    • Fit the valve collets with the special tool.
  1. Repeat the previous steps on all the other valves.

  1. Remove the special tools.

  1. Install the ignition coil.
  1. Install the camshafts.
    For additional information, refer to Camshafts in this section.

Camshaft > < Crankshaft Front Seal